*One package contains 2 bushings you need 2 packages for one board*
The least expensive yet most effect upgrade for any board. Especially for those small or newer riders.
These are Barrel bushings compatible with street trucks that use a 0.5" tall bushing. Typically used as a boardside bushing.
Barrel bushings have more resistant than cones and a consistent ramp in resistance as your turn or carve deeper.
Dimensions
Street Barrel 0.5″ tall x 0.98″ wide
Durometers (Hardness):
60A – Clear Orange
65A - Clear Yellow
70A - Purple
75A - Green
80A - Orange
85A – Blue
90A – Yellow
95A – Red
97.5A – Arsenal Green
Keep in mind that the rounded edge goes towards the hanger of the skateboard truck and fits snugly into the bushing seat.
APS™ Formula: Animated Polymer System
As the name implies, this compound is very lively and offers high rebound with lots of control and lean. For the same durometer, the APS will turn 10% to 15% more than the same durometer of other brands. In addition, the APS does not change much when you tighten the kingpin nut past snug. We recommend tightening to the point where it is difficult to turn the bushing in the bushing seat by hand. Use a flat washer for lower resistance and a cupped washer for higher resistance.
